| |
 |
This Test Stand was designed to test the Lucas Starter Generator as well as a Lucas Oil Cooled Alternator. The Stand uses a 75 HP, DC motor through a gearbox to obtain speeds of 18,000 RPM. A 28 Volt DC, 600 Amp Load Bank as well as a 208/120 Volt, 400 HZ, 45 KVA Load Bank are built in.
|
AC/DC Generator Test Stand
Model D38209 |
|
|
| |
|
| Performs pre-calibration tests on Lear Siegler Voltage Regulation Panels. Contains digital meters, DC power supply, and an assortment of controls. |
 |
| |
51509 LSI Test Panel
Model D38098 |
|
| |
|
 |
Tests aircraft DC generators, regulators, and starters. Separate Drive Skid allows remote location of the control Console. The skid contains the variable load bank, the drive system and fixtures for starter no load speed and locked rotor torque checks as well as the major electrical equipment. Speeds up to 15,800 RPM are provided by the 60 HP drive motor and gearbox. The console contains digital meters and an oscilloscope along with other instrumentation and controls. |
DC Generator Test Stand
Model D37927A |
|
|
| |
|
Designed to carry out the required test procedures on various AC and DC linear actuators and screwjacks used in aircraft systems. Hydraulic system and ram can provide loads to 25,000 pounds. Speed and forces developed by actuators as well as torque of screwjacks can be accurately measured. |
 |
| |
Linear Actuator Test Stand
Model D38223 |
